i have an application that i built into it a "programmer" mode. this
essentially will unhide all worksheets and unprotect everything. i dont know
how to open my vba project though. it is getting annoying that every time i
want to test my workbook_openn statement, after opening the app, i have to
type my vba password to look at my code. yes i know i could just hold off
until testing is complete to put a password on it, but for fixing it down the
line, this would be helpful. TIA.

Opening the password protected project with code is not supported.
Solutions posted here are dependent on Using Sendkeys.

http://tinyurl.com/2p7u35


--
Regards,
Tom Ogilvy


"Spencer" wrote in message
...
i have an application that i built into it a "programmer" mode. this
essentially will unhide all worksheets and unprotect everything. i dont
know
how to open my vba project though. it is getting annoying that every time
i
want to test my workbook_openn statement, after opening the app, i have to
type my vba password to look at my code. yes i know i could just hold off
until testing is complete to put a password on it, but for fixing it down
the
line, this would be helpful. TIA.