I have added a frame to SS. I am adding radio buttons to frame. When I drag
the frame, the buttons come along as wanted.
However, in execution mode the radio buttons don't show. I haven't had luck
trying to reorder since I suspect they are in a different layer from the
frame.
Any clues as to how to set up radio buttons in a frame? (I'm using VBA now
to turn off other buttons when one is selected.)
And is this the correct group?
TIA
--
Gary

Assuming a frame from the control toolbox toolbar:

Where are you using the frame. If in a userform, put down the frame first,
then the buttons.

If on a worksheet, then don't use a frame - it is not really supported.

--
Regards,
Tom Ogilvy


"Gary Labowitz" wrote in message
...
I have added a frame to SS. I am adding radio buttons to frame. When I
drag
the frame, the buttons come along as wanted.
However, in execution mode the radio buttons don't show. I haven't had
luck
trying to reorder since I suspect they are in a different layer from the
frame.
Any clues as to how to set up radio buttons in a frame? (I'm using VBA now
to turn off other buttons when one is selected.)
And is this the correct group?
TIA
--
Gary