| Home |
| Search |
| Today's Posts |
|
#1
Posted to microsoft.public.excel.programming
|
|||
|
|||
Need a code
I need a code that does the following:
If C3D3, B3 value will start blink and if C3<D3, E3 value will start blink. Any help please. Thanks in advance. |
|
#2
Posted to microsoft.public.excel.programming
|
|||
|
|||
|
Need a code
Personally, I would recommend against blinking text, but if you insist on
employing it, this website should help you get started... http://www.cpearson.com/Excel/BlinkingText.aspx NOTE: Pay particular attention to the second of the two points delineated in the Summary section at the bottom of the webpage. -- Rick (MVP - Excel) "MAX" wrote in message ... I need a code that does the following: If C3D3, B3 value will start blink and if C3<D3, E3 value will start blink. Any help please. Thanks in advance. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| split post code (zip code) out of cell that includes full address | Excel Discussion (Misc queries) | |||
| How can I modify my code to offset the defined range and repeat theprocedure instead of duplicating my code? | Excel Programming | |||
| Run VBA code only worksheet change, but don't trigger worksheet_change event based on what the code does | Excel Programming | |||
| Shorten code to apply to all sheets except a few, instead of individually naming them, and later adding to code. | Excel Programming | |||
| Excel code convert to Access code - Concat & eliminate duplicates | Excel Programming | |||
Linear Mode
