I tried to run a macro originally created in Excel 2000, in Excel 200
application. It was running unusually slow and I stopped it by pressin
Ctrl+Break. The macro stopped running, but now every time Itry to run i
again, it gives a pop-up message 'the code was interrupted'. You ca
press Continue, End or Debug. If you press continue, the message pop
up again in a second and you have to press it over and over. The macr
works fine on other PC's, but I am having problems now running it i
both Excel 2000 and Excel 2003. (Tried rebooting the PC as well...)

Any ideas

--
Vlad
-----------------------------------------------------------------------
Vlada's Profile: http://www.excelforum.com/member.php...fo&userid=3682
View this thread: http://www.excelforum.com/showthread.php?threadid=56525

Hi Vlada

CAn you post the code and have you tried pressing debug so to see the
aberant code

Best N10

"Vlada" wrote in message
...

I tried to run a macro originally created in Excel 2000, in Excel 2003
application. It was running unusually slow and I stopped it by pressing
Ctrl+Break. The macro stopped running, but now every time Itry to run it
again, it gives a pop-up message 'the code was interrupted'. You can
press Continue, End or Debug. If you press continue, the message pops
up again in a second and you have to press it over and over. The macro
works fine on other PC's, but I am having problems now running it in
both Excel 2000 and Excel 2003. (Tried rebooting the PC as well...)

Any ideas?


--
Vlada
------------------------------------------------------------------------
Vlada's Profile:
http://www.excelforum.com/member.php...o&userid=36820
View this thread: http://www.excelforum.com/showthread...hreadid=565251

Yes, I tried to debug. It points to 'Open File'. We tried running the
macro with only Excel 2003 installed and it works. It looks like there
is a problem when using both Excel 2000 and Excel 2003 on the same PC.


--
Vlada
------------------------------------------------------------------------
Vlada's Profile: http://www.excelforum.com/member.php...o&userid=36820
View this thread: http://www.excelforum.com/showthread...hreadid=565251