In debuging a Sub I use the Step key (F8) frequently;
Today I'm trying to debug a UDF without the same
success; How do you approach debuging Functions?

Put a break on the first code line (select the line, F9), then in the
worksheet F2 the function, and you should be able to step through then.

--
HTH

Bob Phillips

(remove nothere from email address if mailing direct)

"JMay" wrote in message
news:IODmf.41892$_k3.4752@dukeread01...
In debuging a Sub I use the Step key (F8) frequently;
Today I'm trying to debug a UDF without the same
success; How do you approach debuging Functions?

Thanks Bob;
I was real Close.
Thanks for the clarification.
Jim

"Bob Phillips" wrote in message
...
Put a break on the first code line (select the line, F9), then in the
worksheet F2 the function, and you should be able to step through then.

--
HTH

Bob Phillips

(remove nothere from email address if mailing direct)

"JMay" wrote in message
news:IODmf.41892$_k3.4752@dukeread01...
In debuging a Sub I use the Step key (F8) frequently;
Today I'm trying to debug a UDF without the same
success; How do you approach debuging Functions?