Is there an easy way to select two cells and swap them?

Thanks,

W Wolfe

Depends on your definition of easy. Temporarily, click and drag the
first cell to an empty cell. Click and drag the 2nd cell to the 1st
cell. Click and drag the temporary cell to the 2nd cell.

Depending on how far apart the cells are, it may be easier to use
cut+paste rather than click-and-drag.

--
Regards,

Tushar Mehta
www.tushar-mehta.com
Multi-disciplinary business expertise
+ Technology skills
= Optimal solution to your business problem
Recipient Microsoft MVP award 2000-2005

In article ,
says...
Is there an easy way to select two cells and swap them?

Thanks,

W Wolfe

From the archives:

http://groups.google.com/advanced_gr...ugroup=*excel*

Check out


http://groups-beta.google.com/group/...worksheet.func
tions/browse_frm/thread/5c12eaff46290526/5396f1415d9da591

or http://tinyurl.com/8etsl

In article ,
"William Wolfe" wrote:

Is there an easy way to select two cells and swap them?

Good afternoon William

You could use VBA thus:

Sub Swap()
Dim cval(), cadd()
a = 1
ReDim cval(2), cadd(2)
For Each usrcell In Selection
cval(a) = usrcell.Value
cadd(a) = usrcell.Address
a = a + 1
Next usrcell
Range(cadd(1)).Select
ActiveCell = cval(2)
Range(cadd(2)).Select
ActiveCell = cval(1)
End Sub

Just highlight the two cells and run the macro.

HTH

DominicB


--
dominicb
------------------------------------------------------------------------
dominicb's Profile: http://www.excelforum.com/member.php...o&userid=18932
View this thread: http://www.excelforum.com/showthread...hreadid=379617

This is a bit dangerous -

If only one cell is selected, the data is deleted (by ActiveCell =
cval(2)) and a run-time error is generated by Range(cadd(2)).Select.

Also, if more than two cells are selected, a subscript out of range
error will be generated, though in that case no data is destroyed.

I would at least put a line in like

If Selection.Count < 2 Then Exit Sub

In article ,
dominicb
wrote:

Good afternoon William

You could use VBA thus:

Sub Swap()
Dim cval(), cadd()
a = 1
ReDim cval(2), cadd(2)
For Each usrcell In Selection
cval(a) = usrcell.Value
cadd(a) = usrcell.Address
a = a + 1
Next usrcell
Range(cadd(1)).Select
ActiveCell = cval(2)
Range(cadd(2)).Select
ActiveCell = cval(1)
End Sub

Just highlight the two cells and run the macro.

HTH

DominicB