Page break drag and drop used to cover 8 columns and 60 rows (approx). Width
and length normal. When drag and drop are done, the system adds more page
break lines and states fit to one page is at 10%.

System allowed the changes on 10 of the 15 tabs, then just gives in to
adding page breaks. No Macros, no VBA entries.

Options |View | page break is checked, but greyed out.
Options | Edit | Drag and Dropped is checked.

Please advise on this issue and how to get page to fit 1 to 1, again.

try this
go to files | page setup | choose fit 1 to 1 and adjust to 100% | ok


On May 31, 3:29*am,
wrote:
Page break drag and drop used to cover 8 columns and 60 rows (approx). Width
and length normal. When drag and drop are done, the system adds more page
break lines and states fit to one page is at 10%.

System allowed the changes on 10 of the 15 tabs, then just gives in to
adding page breaks. No Macros, no VBA entries.

Options |View | page break is checked, but greyed out.
Options | Edit | Drag and Dropped is checked.

Please advise on this issue and how to get page to fit 1 to 1, again.