Thank you 'J', I have used Ron's code before on many other sheets and the
'Calendar1' code is working fine, but for some reason when I change it to
Calendar2 and Calendar3 these 2 don't want to work. I have a lot of code on
sheet1 those being code for triple drop-downs and then more code for a single
drop-down. If there is too much code on one sheet will that start to affect
the operation of the other codes?

"JLatham" wrote:

On the off chance that your calendars were given names other than Calendar1,
Calendar2 and Calendar3 you can use this code to determine what their names
on the sheet a

Sub GetShapesNames()
Dim anyShape As Shape
For Each anyShape In ActiveSheet.Shapes
MsgBox anyShape.Name
Next
End Sub

You can put that code into a standard code module or even into the
worksheet's code module and run it from there using [F5] while in the VB
Editor. It will show you the names of all shapes on the active sheet, one at
a time.


"JLatham" wrote:

What is not working for you - there are 2 pieces to Ron's code: moving value
from the calendar(s) to the worksheet, and the other way around.

I placed 3 calendar controls on an Excel 2003 sheet and this code worked for
me:

Private Sub Calendar1_Click()
ActiveCell.Value = CDbl(Calendar1.Value)
ActiveCell.NumberFormat = "mm/dd/yyyy"
ActiveCell.Select
End Sub

Private Sub Calendar2_Click()
ActiveCell.Value = CDbl(Calendar2.Value)
ActiveCell.NumberFormat = "mm/dd/yyyy"
ActiveCell.Select
End Sub

Private Sub Calendar3_Click()
ActiveCell.Value = CDbl(Calendar3.Value)
ActiveCell.NumberFormat = "mm/dd/yyyy"
ActiveCell.Select
End Sub

Did you put the code into the worksheet's code module? Choose the sheet
with the calendar controls on it and then right-click the sheet's name tab
and choose [View Code] from the list. The code module for the worksheet will
appear and that is the module that you should put the code into.




"Lynda" wrote:

I have an Excel 2003 spreadsheet with 3 separate pop-up calendars, basically
there is one at the top, one in the middle and one at the end. I used Ron de
Bruins code for his pop up calendar. I changed the code to €˜calendar 2 and
€˜calendar3 to hopefully get them to work separately but it doesnt seem to
work. Could someone advise me on what I may be doing wrong.

Lynda