Rod

Are you sure you want to do this?

Think about it after reading the following.

You can have a cumulative total in a cell if you have a
separate source cell for adding a new total to the original.

Use at your own risk. I am Posting this just to show you how it can
be done, not as a good solution. You would be much better off to
have another column so you can keep track of past entries.

Goes like this: =IF(CELL("address")="$C$4",C4+D4,D4)

Enter this in cell D4 and then in ToolsOptionsCalculation check
Iterations and set to 1.

Now when you change the number in C4, D4 will accumulate.

Note 1. If C4 is selected and a calculation takes place anywhere in
the Application D4 will update even if no new number is entered in
C4. NOT GOOD.

Note 2. This operation is not recommended because you will have no
"paper trail" to follow. Any mistake in entering a new number in C4
cannot be corrected. NOT GOOD.

To clear out the accumulated total in D4 and start over, select D4
and EditEnter.

Check out Laurent Longre's MoreFunc.xla. Has a Function RECALL
which does what you want without the re-calculation problem, but
again there is no "paper trail" for back-checking in case of errors
in data input.

http://longre.free.fr/english/func_cats.htm

Also see John McGimpsey's site for VBA method and the same caveats as above.

http://www.mcgimpsey.com/excel/accumulator.html


Gord Dibben Excel MVP

On Fri, 22 Dec 2006 10:32:00 -0800, Rod wrote:

If I have a Number in Cell A1 and then want to add say 10 to that number, I
then want to replace the Number in A1 with the new results.

If A1 has 10
Then A2 has 20

I want A1 to then say 30.

If I change A2 to then 10 again
Then A1 changes to 40.

I need like a running SUM in a Cell.

Gord Dibben MS Excel MVP