Thanks Jacob.

I found something that Chip Pearson had made a while back too, and that did
the trick.


"Jacob Skaria" wrote:

Hi Steve

Insert a module and paste the below procedures and try.

Sub AutoRunMe()
Application.OnTime Now + TimeSerial(0, 0, 10), "MyMacro"
End Sub

Sub MyMacro()
MsgBox Now
Call AutoRunMe
End Sub

If this post helps click Yes
---------------
Jacob Skaria


"Steve" wrote:

Morning all.
I'm interested in doing an "autorun" macro that will run every few minutes,
to every couple of hours.
I've looked around here on the newsgroup, and the various forums, and found
some examples, but in the application of them, I don't seem to get what I
want. See code....

Sub AutoRunMe()
application.ontime now + timeserial(0, 0, 10), "MyMacro"
end sub

In my reading, it states that the above code will run every 10 seconds,
following an initial start time of "now."

If however I do this:

application.ontime timeserial( 0, 0, 10), "MyMacro"

it'll only run at 10 seconds past midnight.

I also tried now + timevalue("00:00:10"); it's not repeating every 10
seconds either.


What I'm finding is that the first one does not run every ten seconds-- I
tried it just to make sure it'll do what I need-- and I cannot find anything
else that will allow me to run the macro every few minutes or hours, as I
decide.

I realize that I don't entirely understand it, so I wanted to ask-- how do I
create a macro that'll run every few minutes or so?

Thank you.