AS a guess you are looking for dates that fall between a start and end date?
Are all of the cel values dates that you would be camparing... Try adding an
isdate value check to your code to determine the nature of the cell value...

For Each cell In TimeSrcRng
if not isdate(cell.value) then msgbox cell.address '***
If cell.Value < "" Then
If cell.Value = dtStart And cell.Offset(0, 1).Value <= dtEnd Then
cell1 = cell.Offset(0, -2).Value
Set cell1 = cell1.Offset(1, 0)
End If
End If
Next

--
HTH...

Jim Thomlinson


"Jay" wrote:

I have two workbooks that have been set up with the same layout and formating
etc. When I run a macro that contains the following code (see below), pointed
to one workbook, everything runs fine. But when I point to the other
workbook, I get a Run-time error '13': Type mismatch.

Code from macro:
For Each cell In TimeSrcRng
If cell.Value < "" Then
If cell.Value = dtStart And cell.Offset(0, 1).Value <= dtEnd Then
cell1 = cell.Offset(0, -2).Value
Set cell1 = cell1.Offset(1, 0)
End If
End If
Next

The error occures on line:
If cell.Value = dtStart And cell.Offset(0, 1).Value <= dtEnd Then

How can I figure out what's wrong with the second workbook?