did you manually define the range or did you do it by code.

Manually: go back to menu Insert - Nme - Define and reselect the Range with
the correct worksheet.

Code : add sheet name

"=sheet1!$D$6:$D$7

"ranswrt" wrote:

It show ListFillRange as $D$6:$D$7 which is the correct cell names, but I
don't know if it refers to the right sheet. The sheet with the range that I
want to get the data from is different than the sheet that contains the
listbox.

"Joel" wrote:

You are going to have to look at the properties in the Listbox.

1) go to spreadsheet menu view - toolbars - Control toolbox
2) Press the triangle on the toolbar to go into Design Mode. Design mode
button is a toggle button the Enters/Exit.
3) right click Listbox and select properties. Look at ListRange propertiy
to see if it is correct
4) Press triagle again to exit Design Mode.

"ranswrt" wrote:

There is data in that range

"Joel" wrote:

Now go to your worksheet menu

Insert - Name - Define

Then click on "wrkshtrng"

Next check if there is any data in the address defined by "wrkshtrng"

"ranswrt" wrote:

I change it to :
Sheets("Home").OLEObjects("ListBox1").ListFillRang e =
Range("wrkshtrng").Address
The listbox is blank now.
"Joel" wrote:

Why do you have two double quotes at the end of the line

AGAIN if "wrkshtrng" is a defined name then it should be

"Sheets("Home").OLEObjects("ListBox1").ListFillRan ge = _
Range("wrkshtrng").address


"ranswrt" wrote:

I have a procedure the deletes a sheet and updates a listbox on a worksheet.
I get the following error when this part of the code is ran
"Sheets("Home").OLEObjects("ListBox1").ListFillRan ge = "wrkshtrng""

The error I get is this:

run-time error '-2147352567 (80020009)':
Could not set the listcursor property. Not enough storage is available to
complete this operation.

What could possibly be causing this?
Thankx