Hi Sandy

Right click on sheet tabView Code
In the grey bar on the left side of the code window, click opposite the line
of code where you want to pause.
This will highlight the row (Brown in my case).
Return to your spreadsheet by pressing Alt + F11

Do the operation that should trigger the code, and return to the code
window. If the code is running, then part of the marked line will be
highlighted Yellow. Using the F8 button you can step through the remaining
lines of code.

If the code is not running, it could be that Application.EnableEvents has
been switched off.

In the Immediate window of the VBE (press Control+G to make it viewable, if
not already shown) enter
Application.EnableEvents = True
and press Enter

Then try invoking the code again.
--
Regards
Roger Govier



"Sandy" wrote in message
...
How can I go through a "Worksheet_Change" event manually to check the code
is working as intended?
I believe inserting a breakpoint after 1st line is a start but I don't
know how to do that!
Step by step would be good!
Sandy