Turn ON design mode...
Thanks Tom
"Tom Ogilvy" wrote in message
...
this worked in US English version:
Sub ABC()
Application.CommandBars("Control Toolbox" _
).Controls("&Design Mode").Execute
End Sub
You might need to identify the ID of the control and use FindControl to
return a reference to it, then use the reference to execute it.
--
Regards,
Tom Ogilvy
"Flemming" wrote:
Hi,
When my macro runs I at some point wants to change into design mode -
knowing that I properly can not get back to run mode with out a manual
act.
Anybody know the code to switch to design mode?
Thanks,
Flemming
|