Corey

I think the key here is nothing (updating cells, etc) happen automatically,
you need to set the values on the sheet from the hidden form, then when you
have done this and need the values no longer, unload the form.

--
HTH
Nick Hodge
Microsoft MVP - Excel
Southampton, England
DTHIS
www.nickhodge.co.uk


"Corey" wrote in message
...
So if you .Hide THEN Unload, the values are not updated into a sheet?

But Unload without .Hide does ?
Corey....
"Nick Hodge" wrote in message
...
Corey

A normal procedure would be

'UserForm1 initialisation (Either design time or runtime)
UserForm1.Show (Shows and loads into memory, fires UserForm_Initialize()
event)
'do what you want with the form
UserForm1.Hide
'Read all the controls and place or do with them what you will
Unload UserForm1
'This removes all the values and renders form unreadable (out of memory)
'Start routine again

--
HTH
Nick Hodge
Microsoft MVP - Excel
Southampton, England
DTHIS
www.nickhodge.co.uk


"Corey" wrote in message
...
So to clear the data that was entered and to use the .hide,
The userform should be coded to clear all values upon Initializing to
remove any values that were entered previously if the userform is then
re-.shown?

Corey....
"Nick Hodge" wrote in message
...
Corey

Hide is the only way to dismiss the form and persist the data, Unload
removes it from memory and returns the controls to their design time
state and it cannot be read

--
HTH
Nick Hodge
Microsoft MVP - Excel
Southampton, England
DTHIS
www.nickhodge.co.uk


"Corey" wrote in message
...
What is the best way to close off a userform without unloading the
data.

Userform.hide simply hides the userform,
but is this good enough as a close?
As it still stores the data in the userform if something was placed
there.

Corey....