The problem is that I need to look at both the Date and Time. The data is
engineering information on the position of a servo. To plot this correctly
over midnight needs the date. Also on startup there is a time
synchronisation where the machinechanges from its default time starting in
1970 to current time. Again i need to take that into account.
Data typically looks like this with update rates of either 64Hz or 100Hz.
Timestamps are down to less than miliseconds so Excel has a problem here
anyway.
Serial No. Time Elevation
25772 27 Jan 2000 01:36:34.925 0.033
25786 27 Jan 2000 01:36:34.941 0.082
25800 27 Jan 2000 01:36:34.956 0.159
25810 27 Jan 2000 01:36:34.972 0.253
25824 27 Jan 2000 01:36:34.987 0.368
25834 27 Jan 2000 01:36:35.003 0.511
25848 27 Jan 2000 01:36:35.019 0.698
25859 27 Jan 2000 01:36:35.034 0.824
25873 27 Jan 2000 01:36:35.050 1.011
25887 27 Jan 2000 01:36:35.066 1.148
25897 27 Jan 2000 01:36:35.081 1.318
25911 27 Jan 2000 01:36:35.097 1.478
25921 27 Jan 2000 01:36:35.112 1.653
25935 27 Jan 2000 01:36:35.128 1.796
25945 27 Jan 2000 01:36:35.144 1.950
25959 27 Jan 2000 01:36:35.159 2.109
25969 27 Jan 2000 01:36:35.175 2.307
25983 27 Jan 2000 01:36:35.191 2.428
25997 27 Jan 2000 01:36:35.206 2.604
26007 27 Jan 2000 01:36:35.222 2.763
26021 27 Jan 2000 01:36:35.237 2.911
26031 27 Jan 2000 01:36:35.253 3.071
26045 27 Jan 2000 01:36:35.269 3.236
"Wait" halts the macro running until a time has been reached whereas I need
to find the specified periods of time (in the record) where the servo
performance is to be measured.
"mudraker" wrote:
Sorry I meant to say try Timevalue
Do While TimeValue(Time_Now)) < TimeValue(Calc_End_Time)
You may also need to use datevalue if you need check date as well as
time
Do While DateValue(Time_Now)) < DateValue(Calc_End_Time)
Also have you looked at the wait command - I have never used it myself
--
mudraker
------------------------------------------------------------------------
mudraker's Profile: http://www.excelforum.com/member.php...fo&userid=2473
View this thread: http://www.excelforum.com/showthread...hreadid=535734