Macro for blank cells
Range("A1").Select
Columns(1).Find("", AFTER:=ActiveCell).Activate
I haven't looked at the rest of your code.
--
Regards,
Tom Ogilvy
"Darryl" wrote in message
...
I have some code (see below) that starts at cell A8 and is intended to
look
DOWN until it finds a row with a blank cell in column A and then continues
on
with the IF statement you see in the code. However, the CELLS.find....line
looks to the right and finds a blank cell (not suppose to do this) and
then
the IF statement executes and everything goes down hill from there. Any
ideas?
Do
BEGCELL = ActiveCell.Offset(1, 0).Row
Cells.Find("", AFTER:=ActiveCell).Activate
ENDCELL = ActiveCell.Offset(-1, 0).Row
If ActiveCell.Value = "" Then
Application.ActiveCell.Offset(0, 11).Formula = "=SUBTOTAL(9,L"
&
BEGCELL & ":L" & ENDCELL & ")"
ActiveCell.Offset(0, 11).Copy
Range(ActiveCell.Offset(0, 10), ActiveCell.Offset(0,
14)).PasteSpecial xlPasteAll
Application.ActiveCell.Offset(0, 25).PasteSpecial
xlPasteAllExceptBorders
ActiveCell.Offset(0, -35).Select
If Mid(ActiveCell.Offset(1, 0).Value, 1, 12) =
"Grand totals" Then Exit Do
End If
ActiveCell.Offset(1, 0).Select
Loop
Thanks in advance,
Darryl
|