Ok I found it is related to Page Setup. it was set at 1 page wide and
1 page long. I adjust manually and it displays differently. How do I
change the PageSetup to reflect the correct qty of pages? I thought
changing things by inserting PageBreaks was enough in code.

ScottD

If you try enough you eventually figure out what you wanted to blame
on something else was you.

--
Regards,
Tom Ogilvy

"nope" wrote in message
...
Thank You Tom.
I have set a printarea range of "a1:J500" (this changes and is set in
code although J is the absolute right column)
and the pagebreaks don't appear in pagebreakpreview although they are
set by designating
A3 or A130 or A222 as the location to insert them.
Of course the actual area to insert them changes based on the row
location of a calendar week header postion.
Appreciate your input

ScottD




PageBreak preview mode

if you set a printarea that doesn't include your pagebreaks, then they
wouldn't appear in this view. Only pagebreaks that are within the white
area.

--
regards,
Tom Ogilvy


"nope" wrote in message
...
I have been working on adding pagebreaks within some report results
sheets.

Everything indicates that they are being created correctly and I have
been able to run some things which show they they are there, thanks to
some good examples from all you folks.

However on screen in PageBreak preview mode no page breaks are visible
except the exterior boundaries of the PrintArea.
Is the set PrintArea doing this?

I have never been much involved in the printed output of reports.
Thank You,

ScottD