I added several new controls to a userform and found that there was a
noticable increase in the time it took to load. I removed the controls one
at a time and was able to isolate the problem to two frames on the userform.
I did some additional testing with a new userform on which I only attached
frames. When I put only one frame on the userform it loaded in 15
milliseconds while two frames took 140-165 milliseconds. I know this isn't a
long delay, but it is annoying that the form does not load "instantaneously."
From a performance perspective, two frames was approximately 8-10 times
slower than one. I tested other controls and each additional control had
almost no impact on the load time of the form. Has anyone else experienced a
similar situation with frames? Is there a way to avoid/correct this? Any
help would be greatly appreciated.

Dan