Thank you for your help - I created the macro in the first sheet tab and when
I run it for the 2nd tab, the 3rd tab and so on - It applies the data from
the first tab. What am I doing wrong?

Thank you

"bj" wrote:

Record a macro changing the range in the charts in one sheet.
you may have to change it a little, but should able to just run the macro
on each sheet to change all of the ranges.

"Karen" wrote:

I am using the following raw data for my line chart. In this case I have 5
charts on each sheet tab. One for Bolts, one for Nuts and so on.. I also
have 25 sheet tabs for each customer. The way it's set up now is that the
line chart only covers the data range of year 2002, 2003 & 2004. When I want
to add each year I have to go into 5 charts on each tab and 25 tabs for each
customer to select that data range. Initially, It should have been set up to
highlight the data range up an until year 2008 so I could just plug in the
numbers for each year and that data would populate the chart. Should I just
go into each chart and each tab and highlight the data until 2008 or is there
an easier way to do this so I don't have to do all that highlighting?

Thank you, Karen

2002 2003 2004 2005 2006 2007
2008
Bolts 2145 2500 3245
Nuts 5214 5628 5487
Screws 526 650 698
Elbows 457 487 412
Nails 1248 1348 1578