|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 26th 12, 10:33 PM
|
|||
|
|||
Page Preview showing placement of page breaks
I just started using Office 2010 after many years of 2003.
In 2003 with a long sheet I could see dotted lines to show short or long pages. Also I could make sure my printout was at 100% if I checked and it was reduced and I increased it to 100% going back to my spread sheet I could see the dotted lines showing where my page breaks should be so I wasn’t trying to get too many rows on a 8.5 x 11 sheet of paper. This is my first post so I hope I’m explaining my problem. I have been going into Print Preview and seeing how much space I have at the bottom on the page, but this is a pain 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| page breaks and print preview | aj | Excel Discussion (Misc queries) | 0 | January 7th 10 10:44 PM |
| Vertical page breaks won't drag in Page Break Preview | Caroline | Excel Discussion (Misc queries) | 0 | July 14th 09 12:19 PM |
| Page Breaks. They are showing up around every cell! | Tammy | Excel Discussion (Misc queries) | 0 | August 29th 08 09:00 PM |
| How do I do page breaks when view menu doesnt page break preview | HeatherF55 | Excel Discussion (Misc queries) | 0 | September 21st 07 04:24 AM |
| I can't move my page breaks in Page Break Preview | btaft | Excel Discussion (Misc queries) | 5 | June 21st 06 02:25 AM |
Linear Mode
